Hot rooms upstairs, a drafty attic or a power bill that keeps climbing? We spray foam that seals the gaps and slows the heat.
Spray foam insulation in Lake Charles is foam we spray into your attic or open wall cavities, where it seals the gaps air leaks through and slows heat in the same layer, so a hot upstairs room has a real chance to cool down.
Most calls start with a room that won't cool off, usually upstairs or over the garage. When I go up into the attic, I often find a few inches of tired insulation and open gaps around can lights, pipes and the hatch letting hot air straight through. Spray foam fixes both at once, but it isn't always the right fit for your house.
The price moves with how many square feet you want covered, how thick the foam goes and whether it's open-cell or closed-cell foam, a dense foam that blocks moisture. Old insulation that has to come out first adds to it. The schedule mostly turns on that removal and on finding days when your household can be out. Your estimate comes after I've measured the space and written down what's there.
Foam sticks to whatever it touches and covers it up, so the look beforehand matters as much as the spraying. These are the things I check first, and why each one matters.
Once foam covers the roof deck or the inside of a wall, a slow leak or a bad wire gets much harder to spot. If I see water stains, soft wood or wiring that needs a look, I show it to you, and we plan around it before anyone sprays.
Spraying over insulation that got soaked or is full of droppings just seals the problem in. I check how many inches are up there and what shape they're in, and if the old layer has to come out, that goes in the estimate as its own step.
That room runs hot because it has outside air on several sides and air leaking up from the garage below. I look at the floor, the short knee walls along the sides and the ceiling, because foam can seal and insulate those spots where loose fill won't stay put.
Here's how a spray foam job runs with us, from your first call to the walkthrough. Most of the planning happens before anyone sprays, because that's when problems are easy to fix.
Call (337) 474-1146 or fill out the form and tell us what's going on, whether that's a room over the garage that never cools, drafts or old insulation you're not sure about. We'll set a time to come out.
I come out myself, look over the attic, walls or crawl space, measure and write down what I find. Then you get an estimate that spells out the foam type, the areas and anything that has to happen first.
If you go ahead, we check permit needs with the office that covers your address and pick dates when your household can be out. Then our crew does the work the estimate describes.
We clean up, then walk you through the finished job area by area, including anything we noted along the way, so nothing gets covered up without you knowing about it.
The big decision is open-cell or closed-cell foam. Before you choose, I lay out what each one does in your walls or attic, where it helps and where it doesn't, because the right pick depends on your house and what you're trying to fix. You'll find the main differences in the questions further down.
Foam isn't always the answer. It costs more than loose fill, and it seals air while it insulates, which pays off most when your ductwork runs through the attic. If it doesn't, sealing the gaps and topping up the old layer with blown-in insulation, loose fill blown through a hose, usually gets you more for the money. I'll tell you which way I'd go for your attic insulation, and why.
Spray day takes planning too. We work out with you when the household will be out while we spray and how long you'll stay away, going by the foam maker's re-entry time, the point when it's safe to come back in, and until the house has aired out.
A softer, lighter foam that expands into odd spaces and does a better job of quieting noise. It's a common pick under the roof deck when the attic holds the ductwork and the budget matters.
A dense foam that blocks moisture and packs more insulation into each inch. It's the one I'd look at for walls where water could get in, or tight spots without room for thickness.
We reply within one business day. I come out, look over the space, measure and write down what I find, then give you a free estimate on site. There's no obligation to go ahead.
(337) 474-1146Building permits in Lake Charles come from the city's Permit Center. Calcasieu Parish requires a permit before any remodeling or renovation project, and its list names re-roofing but not spray foam, so the list alone doesn't settle your job. We check with the city or parish office that covers your address before we start, and if a permit's needed, we apply and keep you posted. If you'd rather ask yourself, the Permit Center's number is 337-491-1294.
Our humid weather decides how a foam attic gets built here. Vents or leaks in a spray foam attic let in moisture that causes problems, so these attics are sealed with no vents. Extension advice for the Gulf region says a sealed attic in a warm climate needs a slight A/C supply and return to keep its humidity down, and that open-cell foam is OK here with indoor humidity control and more forgiving of roof leaks.
The same advice says a sealed foam attic shouldn't hold fuel-burning equipment unless it's the direct-vent, sealed-combustion kind that draws its air from outside, so I note any gas furnace or water heater up there at the estimate. Around Lake Charles, and in Sulphur and Moss Bluff, we see a lot of ductwork running through hot attics, which is often what makes foam worth a look.
I learned insulation on a municipal crew, where every job got written up and checked before anyone signed off. I started Lake Charles Insulation Company in 2023 to bring that habit to homes and businesses here, and three years in, it's still how we work. I come out and write your estimate myself, and our crew does the job with me or a lead installer on site.
We're licensed and insured. Your satisfaction, guaranteed. I explain the choices plainly and show you what we found, because you should know what you're paying for before you sign anything. To set up a visit, call (337) 474-1146 or send us the form.
If your ductwork isn't up there and the attic floor just needs more depth, a standard attic job may cool those rooms for less.
Loose fill is the quick way to bring a thin, settled attic layer back up to depth once the gaps are sealed.
We're based in Lake Charles, LA and work in the cities around it, including Sulphur, Jennings and Orange, TX, plus areas like Moss Bluff and Prien. Pick yours below to see what we run into there.
Spray foam insulation in Lake Charles usually costs about $1,600 to $4,000 for 1,000 square feet of coverage with 3 inches of insulation. That's the going rate around here, not our price, and open-cell foam sits toward the low end while closed-cell sits toward the top. Your own number comes from the estimate after I've measured the space.
Pick closed-cell if you want the most insulation per inch or a backup against water in your walls, and open-cell if quiet and a lower price matter more. National guidance puts closed-cell at about twice as energy efficient per inch, and in a wall cavity it can keep water out if a leak gets past the wall's water-shedding layer. Open-cell is a much better sound barrier.
Yes. Federal guidance says everyone in the household should be out while the foam goes in and stay out until it cures and the house is aired out and cleaned, so plan for the kids and pets too. Some foam makers say 24 hours before you come back, though it can vary, and you can ask the maker or supplier for your product's time.
Line up somewhere for everyone to stay during the spraying and the cure time after it, and clear stored boxes out of the attic so we can reach the roofline and the edges. If we're doing walls, move furniture and anything you don't want dusted with overspray away from them.
Federal guidance says people with asthma, respiratory allergies, skin conditions or a past reaction to a foam chemical should carefully review the product information first, and they may want to consider other kinds of insulation. Tell me about it at the estimate, and we'll go over the product together or plan a different kind of insulation.
For a home improvement job that totals over $7,500 but not more than $50,000, the Louisiana State Licensing Board for Contractors requires a home improvement registration. That total counts labor and materials together, no matter who buys the materials. Ask any contractor you're considering how they're set up for a job your size.
Have your rough square footage and the areas you want insulated handy when you call (337) 474-1146 or fill out the form, so we can talk through open-cell or closed-cell before I come out.
